Briefly describe the common faults and treatment methods of various vending machines

1. Vending machine goods: due to the arrival of the spring coiled goods, when the spring rotates in the machine, the goods will produce a squeezing force. The squeezing force has both a positive squeezing force and an oblique squeezing force, acting on the positive squeezing force. The cargo is easy to fall, even FAL. This will cause the goods to be stuck below the arrival of the goods (under the spring); under the action of oblique extrusion, the friction between the arrival of the goods and the sides of the protective plate will increase, and when the friction is large, the goods will not be shipped normally.　　 Solution: First take out the stuck items, then enter the 'fault' item on the vending machine management page, and choose to clear the card failure. And make corresponding changes in the future product launch business, mainly because the size of the main product should be as consistent with the arrival size as possible, not too small or harder than the size of the arrival spring! 　　 2. The vending machine is out of stock, no Change. This situation is mainly caused by the following reasons: 　　1, there is no change in the changer; 　　2, there is change in the changer, but the default amount of change in the system is zero; 　　3, the changer is stuck; 　　4, paper money device The dust is too serious. Solution: 　　1, make up the change; 　　2, enter the system management page, check if there is no record after the last change was made (some vending machines need to manually enter the amount of change after making the change), if the amount is 0, please Modifications; 　　3, disassemble the banknote device to remove the jammed currency; 　　4, disassemble the banknote device with a brush to carefully and carefully clean up the dust or send it back to the manufacturer for cleaning.　　 3. The vending machine puts in change, and the change does not enter the change device but is instead deposited in the cash collection area. This problem is mostly due to an error in the banknote device system (the failure to shut down for a long time). Solution: Enter the system management page three minutes after shutting down, and then use a small stick to penetrate the reset button of the banknote device to reset (after inserting the small stick and pressing the reset button, you will see the light on the banknote device opening and then turning off again Let go if it’s on) Wait a few minutes and then turn it off and restart it again to basically solve the problem! 　　 Fourth, the light on the vending machine's banknote receptacle does not turn on or turns on and off, and at the same time put the banknote into the machine without sucking money. There are mostly two possibilities for this kind of problem: 1. It is caused by foreign objects in the banknote device, and 2. The iron cash box under the banknote device is not installed properly.　　Solution: Open the banknote device, shut it down after removing the foreign objects, and then turn it on again. Turn off the power of the machine and reinstall the iron cash box! Previous post: The daily maintenance of the vending machine requires long-term persistence!