All kinds of automatic coin vending machine common faults and processing methods

Various automatic coin vending machine common faults and processing methods, automatic coin vending machine card goods: because use of the goods, the spiral spring spring rotation when the machine is shipped to commodity produce extrusion pressure, extrusion, there are also positive oblique extrusion pressure under the action of forward extrusion goods easily flopping, or even fall. This will lead to commodity card under the arrival of the goods ( Under the spring) ; Under the action of oblique extrusion pressure will increase goods and goods to the friction between the two sides guard board, when the friction is bigger to the normal goods can't shipment. Solution: take out the stuck goods first, and then we will enter the page of the vending machine management 'fault' choose clear card goods in fault. And in the future operation of goods put make a corresponding change, mainly is the size of the main items as far as possible consistent with the arrival of the goods size, not too small not greater than spring arrival plug size! Second, the automatic coin vending machine is out of the goods, don't change. Lead to this situation is the main reason: 1, the change in no change; 2, change with the change can be in the system change the default number is zero; 3, change the card currency; 4, paper dust were too severe. Solution: 1, make up the change; 2, enter the page of system management, check whether last after filling the change wasn't record ( Part of the vending machine to fill after the change need to manually add input into the change number) , if the quantity is zero, please modify; 3, open notes to take out the stuck of currency; Four, dismantled notes for brush carefully and carefully remove dirt and send back to the factory to clean up. Three, automatic coin vending machine input change, change instead to enter the change in deposit money zone. The problem is mostly due to the paper money system error ( For a long time failed to shut down a rest) 。 Solution: turn it off after three minutes into the boot system management page and then with a small stick deep reset button to reset the device a bill ( Insert small stick after holding down the reset button, will see a paper puts the lights went out and then lit it let go) Wait a few minutes after shutdown, restart again basically solve the problem! Four, automatic coin vending machine paper lamp not bright or bright and dark, at the same time into the paper money machine, not into money. Most of such problems there are two possible: 1, due to paper memory some foreign body, 2, paper, iron box didn't installed. Solution: open notes, foreign body after shutdown, it is ok, install the machine shuts off power supply to iron cashbox is ok! In an article: no one self-help vending machine or become a new generation of intelligent profitable industry