What should I pay attention to when replenishing the vending machine? Which Guangdong vending machine manufacturer is better?

When the vending machine is replenishing goods, it is necessary to carefully arrange the location according to the specific characteristics of the product, so that the vending machine can put the most products, but also improve the consumer's shopping experience and reduce the loss of the operator. What should I pay attention to when replenishing the vending machine? 1. The cargo lane of the vending machine with a flat-bottomed track should be as low as possible for low- and flat-bottomed goods. 2. When placing bottled beverages, place the bottle cap down as much as possible, which can effectively solve the awkward situation of standing up after the beverage bottle falls on the ground. 3. The same kind of goods should be placed in the same spring cargo lane. It is best to fill the goods every time. If you are not satisfied with it, leave the innermost position empty. There should be no space at the front end of the spring cargo lane. 4. When placing goods in the vending machine, the upper end of the product must not be tilted outward (you can stand or tilt inward), which can effectively reduce the occurrence of jams caused by the top of the product. 5. Drinks packed in Tetra Pak bricks and cans should be placed on a flat track to reduce the card rate. The frictional resistance of cargo moving on the freight track is greater than that of plastic bottles, and the flat-bottom track can effectively reduce the occurrence of cargo jams. 6. The aerated beverages (that is, carbonated beverages filled with carbon dioxide) should be placed as far as possible on the low-level vending machine cargo lanes. Otherwise, the beverages may fall and the customers may open the beverages, which will not only increase the operators. Loss also greatly affects the customer's buying experience. 7. Goods of different sizes should be placed on the goods lanes of different specifications. If you don’t know where to put the goods, we can use a ruler to measure the diameter and pitch of the spring, and then compare the size of the product (this method is suitable for a fixed package ), in fact, the most direct way is to put the goods on the cargo lane of the spring to experience it, and the card is not too tight and will not fall off from the space in the center of the spring. The above is what should be paid attention to when the vending machine is restocking? Which Guangdong vending machine manufacturer is better? I hope it will be helpful to everyone. That's it for this time, see you next time. Previous: Dongguan vending machine manufacturers: What is the development prospect of vending machines? Next: Where is the vending machine suitable for? Which vending machine manufacturer in Guangdong is better?