Professional Haloo Vending Machine Manufacturer & Supplier.
How to prevent the coin-operated beverage vending machine from getting wet?
Merchants must pay attention to that after the coin-operated beverage self-service vending machine freezer arrives at the store, when it is placed, the cabinet body of the freezer should not be close to the wall, and a certain gap should be kept between the wall and the wall. In rainy spring and Akita, the wall The surface is easy to be damp and leached out water, and the wet wall will affect the parts in the freezer and damage the parts. Therefore, when placing the freezer and freezer, it is recommended to place them 10 cm away from the wall. The inside of the coin-operated beverage vending machine should be defrosted frequently. Frost will form inside the cabinet of the freezer after a long time of use, and then it will freeze into ice. This is a situation that many people often encounter when using the freezer. At this time, the merchant can cut a relatively thick piece according to the internal specifications of the freezer. Plastic film, paste it on the part of the freezer that is prone to frost, do not use glue, just paste it. Clean in time. After using the coin-operated beverage vending machine freezer for a long time, some water will accumulate inside. Merchants should pay attention to clearing it in time and try to keep the freezer in a dry environment. Long-term water accumulation will cause many small problems in the machine, so after using it for a period of time Finally, remember to clean up in time. How to deal with dampness? 1. Most of the structural parts are not afraid of water, they can be cleaned with distilled water or wiped with alcohol, and after drying, put it for a period of time before using it. Be careful not to change the resistance of the movable parts. 2. For circuit boards, if the time of water entering is too long, they must be replaced; if the time is short, they can be cleaned with distilled water for a while, then cleaned with high-concentration alcohol, dried with a hair dryer, and dried for a certain period of time. Use it for a while. 3. For electrical components, the leakage protection must be replaced first. It is difficult to get out after water enters it. For safety, please replace it! 4. For electric wires, drain the water in the pipe, clean it with distilled water, then use alcohol, and dry it used later. 5. Remember not to use tap water, let alone mineral water to rinse circuit boards and electrical components, because there are too many charged ions in these two kinds of water, and short circuits are easily formed after cleaning, which poses a safety hazard.
Everyone who has a commercial vending machine wants it to look vending machine manufacturers. However, in order to achieve that, it normally involves investing in a commercial vending machine vending machine. Haloo Automation Equipment Co., Ltd can offer you the best solution.
Haloo Automation Equipment has a whole range of different items to help you make an informed choice every time you make a purchase. Check it!
vending machine has its grasp on oversees market also and has a very good repute.
